Linerloks and Plugloks

Linerloks are a low profile, non-destructive (no holes through the substrate) method for fastening a polymer liner to the substrate.  They are placed inside the countersunk holes on the panel. If you are installing a Smooth Move lining kit these hole profiles will already be in the proper locations on the sheet. If you are drilling your own liner, two-stage Linkerlok tools are available.  Linerloks or weld washers are typically used when there is no access to the backside of the unit being lined and/or you are installing a thin liner and need a low profile fastener.  A weld pool is created in the inside hole of the linerlok bonding the fastener to the surface of the substrate.  After the Linerlok is installed the top will be1/4" off the surface of the steel.    

Linerlok weld washers and plugs

Linerloks come in: Aluminum, Stainless Steel (for food safe industries), Mild Steel and Zinc plated.  

TIVAR® plugloks come in:

  • Blue for TIVAR 88®
  • Nat for UHMW Natural
  • White for TIVAR H.O.T.® (made from TIVAR H.O.T.®)
  • Black for Durapro®
  • Grey for Quicksilver® or Silverslide.

All stock materials and sizes shipped same day.

Need panels to match your new fasteners?  Check out our

Smooth Move Banner

                                           

 

Need advice on which fastening system to use?  Give us a call at 1-800-642-7797 or

Contact us today